| A research title and outline |
Name |
Position |
| Experimental and simulation researches on influence of temperature on nano-scratching process of silicon wafer |
Hidemitsu Okabe |
Ibaraki University, Graduate student |
| Measurement of deformation behaviour near discharge point by using optical fiber sensor |
Yoshiaki Akematsu |
Tokyo University, Specially Assigned Assistant |
| Dynamic behavior of feed drive system around Quadrant changes in circular motion |
Ryuta Sato |
Tokyo University of Agriculture and Technology, Assistant |
| Study on prediction and avoidance of chatter in milling process with CAD/CAE and impulse sound |
Yosihisa Naitoh |
Nissan Motor Co., Ltd., Engineer |
| Curved interpolation CL data creation for 5-axis control machining expressed by non-uniform B-spline |
Yuki Tominaga |
Keyence Corporation, Engineer |
| 5-axis control tool path generation using curved surface interpolation |
Masatoshi Morikawa |
Nissan Motor Co., Ltd., Engineer |
| Monitoring method of cutting force by using additional spindle sensors |
Motoyuki Sugihara |
Kyoto University, Master's course, Sophomore |
| Development of ultrasonic circular vibration assisted micro aspherical polishing system |
Akinori Inagaki |
Kobe University, Doctoral course, Freshman |
| Importation method of terminal contact characteristics of the joint into the FEM analysis |
Kazuhiro Kikumori |
Olympus Corporation, Researcher |
| Imaginary motor control for the table of machine tools with 3 linear servo motors |
Yasuhiro Kakinuma |
Keio University, Assistant |
